Alcatel-Lucent IAP93 Podręcznik Użytkownika Pobierz pdf (Strona 232)

232 | DHCP Configuration AOS-W Instant 6.3.1.1-4.0 | User Guide

Figure 76 New DHCP Scope: Distributed DHCP Mode

3. Based on type of distributed DHCP scope, configure the following parameters:

Name Description

Name

Enter a name for the DHCP scope.

Type

Select any of the following options:

l Distributed, L2— On selecting Distributed, L2, the Virtual Controller acts as the

DHCP Server but the default gateway is in the data center. Traffic is bridged into

VPN tunnel.

l Distributed, L3— On selecting Distributed, L3, the Virtual Controller acts as both

DHCP Server and default gateway. Traffic is routed into the VPN tunnel.

VLAN Specify a VLANID. To use this subnet, ensure that the VLANID specified here is

assigned to an SSID profile. For more information on SSID profile configuration, see

Configuring VLAN Settings for a WLAN SSID Profile on page 89 and Configuring

VLAN for a Wired Profile on page 103

Netmask If Distributed, L2 is selected for type of DHCP scope, specify the subnet mask. The

subnet mask and the network determine the size of subnet.

Default router If Distributed, L2 is selected for type of DHCP scope, specify the IP address of the

default router.

DNS Server If required, specify the IP address of a DNS server.

Domain Name If required, specify the domain name.

Lease Time Specify a lease time for the client in minutes.

IP Address Range

Specify a range of IP addresses to use. To add another range, click the + icon. You can

specify up to four different ranges of IPaddresses.

l For Distributed,L2 mode, ensure that all IP ranges are in the same subnet as the

default router. On specifying the IP address ranges, a subnet validation is

Table 47:

Distributed DHCP Mode: Configuration Parameters

1 2 ... 227 228 229 230 231 232 233 234 235 236 237 ... 334 335

Brak uwag

Alcatel-Lucent IAP93 Podręcznik Użytkownika Strona 232