
In the CLI
To change the name:
(Instant Access Point)# hostname <system-name>
Updating Location Details of an OAW-IAP
You can update the physical location details of an OAW-IAP by using the AOS-W Instant UI or CLI. The system
location details are used for retrieving information through the SNMP
sysLocation
MIB object.
In the AOS-W Instant UI
To update location details:
1. In the AOS-W Instant main window, click the System link. The System window is displayed.
2. In the General tab of System window, specify the location of the an OAW-IAP in the System location text box.
3. Click OK.
In the CLI
To update location details of an OAW-IAP:
(Instant Access Point)(config)# syslocation <location-name>
(Instant Access Point)(config)# end
(Instant Access Point)# commit apply
Configuring External Antenna
If your OAW-IAP has external antenna connectors, you need to configure the transmit power of the system. The
configuration must ensure that the system’s Equivalent Isotropically Radiated Power (EIRP) is in compliance with
the limit specified by the regulatory authority of the country in which the OAW-IAP is deployed. You can also
measure or calculate additional attenuation between the device and antenna before configuring the antenna gain. To
know if your AP device supports external antenna connectors, see the
Install Guide
that is shipped along with the AP
device.
EIRP and Antenna Gain
The following formula can be used to calculate the EIRP limit related RF power based on selected antennas
(antenna gain) and feeder (Coaxial Cable loss):
EIRP = Tx RF Power (dBm)+GA (dB) - FL (dB)
The following table describes this formula:
Formula Element Description
EIRP Limit specific for each country of deployment
Tx RF Power RF power measured at RF connector of the unit
GA Antenna gain
FL Feeder loss
Table 14:
Formula Variable Definitions
AOS-W Instant 6.3.1.1-4.0 | User Guide Initial Configuration Tasks | 69
Komentarze do niniejszej Instrukcji